This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Using the other eth ports

I apologize in advanced for the newbie question.

I have an SG125>9.306-6
One ISP into eth1
10.10.10.0 LAN on eth0
Firewall is set to hand out DHCP.

How do I enable ports eth2-eth7 so that I can plug in a device and have it receive an IP address from the firewall so that it can access the internet.

In Interfaces and Routing I do not have a bridging option, all that is available to me is the ability to create a LAG group.

Would creating the LAG group achieve what I want to do?

Thank you

This thread was automatically locked due to age.

Parents

0 BarryG over 10 years ago

Do you want to use your existing LAN, or setup new LANs / DMZs?

If the latter, you'd click "New Interface", setup a new network, DHCP, DNS, MASQ, etc.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 10 years ago

Do you want to use your existing LAN, or setup new LANs / DMZs?

If the latter, you'd click "New Interface", setup a new network, DHCP, DNS, MASQ, etc.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Using the other eth ports

Submitted a Tech Support Case lately from the Support Portal?