This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

High Availability Deployment

Hi, I'm about to start work on deploying 2 servers using High Availability on Sophos UTM 9.3 and just wanted some advise on connecting up the hardware.

I'm currently running the following:

Router > Sophos UTM > Local Network Switch

I'm assuming because I would now have two servers I would need a switch in between the Router and UTM (The router is single port). So it would now be:

Router > Switch > Sophos UTM > Local Network Switch.

Does this sound right? I would also assume that I would put in an unmanaged switch for security?

Thanks
Chris

This thread was automatically locked due to age.

Parents

0 chrisbli over 10 years ago

Thanks for the reply, the router is BTNet so wouldn't be able to replace it.

In terms of security I meant that because its unmanaged there is nothing to remotely connect to considering its on the outside of the firewall.

If this is a good set-up I could always keep another switch boxed up incase it did decide to fail. I would end up getting something cisco based though so not to worried about the failure rate [:)]

Thanks
Chris
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 chrisbli over 10 years ago

Thanks for the reply, the router is BTNet so wouldn't be able to replace it.

In terms of security I meant that because its unmanaged there is nothing to remotely connect to considering its on the outside of the firewall.

If this is a good set-up I could always keep another switch boxed up incase it did decide to fail. I would end up getting something cisco based though so not to worried about the failure rate [:)]

Thanks
Chris
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

High Availability Deployment

Submitted a Tech Support Case lately from the Support Portal?