This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Handling Tagged vlan packets

I'm trying to establish an enterprise wide vlan that spans several UTMs and switches.  As I understand it, if I need to forward the tagged vlan packets, I need to create the same vlan on both physical interfaces, is that correct?

We already have a routed UTM infrastructure that we need to keep, linking different subnets together, but I also need to create a new sitewide lan (same subnet) for DCOM reasons.  I'm suggesting to implement a sitewide vlan that sits ontop the existing physical lan, will that work on UTM?

For switches I use a trunk port, but UTM I'm unsure of the required config.

Thanks


This thread was automatically locked due to age.
Parents
  • Hi,

    Are you planning to use the same network (for example 172.16.1.0/24) across several different sites ?
  • Hi,

    Are you planning to use the same network (for example 172.16.1.0/24) across several different sites ?


    That's the general idea, I want to span 172.16.99.x over the existing infrastructure.  I would normally use routing, however, our application uses DCOM and I can't route that protocol. hence the spanned vlan.

    Is such a configuration possible with Sophos, or do I need to install additional hardware to establish a enterprise wide LAN?
Reply
  • Hi,

    Are you planning to use the same network (for example 172.16.1.0/24) across several different sites ?


    That's the general idea, I want to span 172.16.99.x over the existing infrastructure.  I would normally use routing, however, our application uses DCOM and I can't route that protocol. hence the spanned vlan.

    Is such a configuration possible with Sophos, or do I need to install additional hardware to establish a enterprise wide LAN?
Children
No Data