Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 22 replies
  • Subscribers 2 subscribers
  • Views 9914 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't create a bridge

politby
I am attempting to set the UTM up in bridge mode, following these instructions:

Configuring Web Filtering and Application Control in bridged mode for a Sophos UTM

After completing the "Initial setup" with one of my 2 NICs as internal, the other one as WAN and then deleting the WAN interface as instructed, I am stuck. There is only one NIC listed (the one I just freed by deleting the WAN interface) so creating a bridge cannot be done. 

Makes sense because the other NIC is used by the internal interface.

Do I need 3 NICs in order to do this?


This thread was automatically locked due to age.
Parents
  • 0
    Interfaces, before deleting the external one to free up for bridging. Note network cable is unplugged:



    Deleting the external interface:



    Setting up the bridge. Only the freed-up NIC is available so have to convert:

Reply
  • 0
    Interfaces, before deleting the external one to free up for bridging. Note network cable is unplugged:



    Deleting the external interface:



    Setting up the bridge. Only the freed-up NIC is available so have to convert:

Children
No Data