UTM9: 9.113-1
Home Edition
Not sure if this is the right forum, but I have a question concerning the listing of active IP addresses on the UTM9 appliance. For home edition there is obviously a (very generous) limit in supported IPs. While I am amazed at the rate that I am consuming IPs with mobile devices, home automation, VOIP, etc., I did realize that my IP count went through the roof after adding my cable provider to the UTM appliance.
I have connected an interface for Time Warner Cable as Ethernet DHCP and it connects to the cable modem receiving the following IP and netmask: 68.203.x.***/19
As a result, I now have a bunch of 68.203.x addresses populating my Active IP addresses table, eating up my usable license count.
While I understand that the system sees these addresses, should it not only list IP against the license count that it (UTM9) actively protects?
Any clarity would be greatly appreciated.
Best,
Oliver
This thread was automatically locked due to age.
