This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM ESXi vs Shuttle DS81

Hello all!

I am looking to setup a UTM box for my home network to play around with (learn) and take advantage of the huge feature set that is offered with the home edition.

I currently have two ESXi 5.5 Update 1 hosts (Core i7-2600K) with 24GB of RAM in each and share the load of 36 VMs (not all are on).  They have 5 NICs in each and the network breakdown like this:

Current

DSL Modem----Cisco Router-----Cisco Switch----Cisco Switch

The Cisco router is the GW for all subnets

Future

DSL Modem----UTM----Cisco Router-----Cisco Switch----Cisco Switch



vSwitch 0 (2 NICs dedicated)
Vlan 5 Mgmt
Vlan 10 LAN (wireless/media streaming)
Vlan 15 Servers
Vlan 25 VMotion
Vlan 30 VPN (Cisco DMVPN)
Vlan 35 FT


vSwitch 1 (2 NICs dedicated)
Vlan 20 iSCSI multipathing (Synology DS412+)


ESXi 1

2 x NICs teamed for all Vlan except iSCSI
2 x NICs iSCSI multipathing to Synology NAS
1 x NIC unused (potential UTM external NIC)

ESXi 2

2 x NICs teamed for all Vlan except iSCSI
2 x NICs iSCSI multipathing to Synology NAS
1 x NIC unused (potential UTM external NIC)




First option:

Shuttle DS81                        $210
Intel Core i3-4330 Hasswell    $140
Startech USB 3.0 NIC (DMZ)  $35
Corsair Vengeance RAM 8GB   $75
OCZ 120GB SSD (I currently have this)

Roughly about $460 from Newegg


Second Option

Virtualized UTM with  3 x VMXNET NICs

I would like to use the spare NIC I have in each host as the external interface for UTM and have the other two NICs mapped to my internal network and an DMZ interface for anything internet facing.


So I guess my question is what are the benefits for each option? Obviously money from the start, but I would I would like to accomplish the same level (if possible) of usability and security of using dedicated hardware.  I am also looking for detailed info for setting of the network configuration for ESXi. I know a separate vSwitch will be needed to map the external UTM interface to the extra physical NIC i have in each host, but I am open to options.

I have search through this forum and have seen a couple of examples, but not quite what I’m looking to accomplish with the hardware I currently have.  Let me know if greater detail is needed


Thoughts?
MG


This thread was automatically locked due to age.
Parents
  • Tom,

    Not everyone has access to vSphere licensing with HA or FT. Essentials Plus (w/ HA) is over $5000, regular vSphere w/ vCenter (w/ FT) is close to $7000. That's not including cost of shared storage. Did this exercise three years ago and vmware plus hardware came to over $30k.

    By comparison, my home server is around $3k, including vSphere Essentials license.

    One corner case where a Active-Passive pair works well on ESX is the single host home use scenario. [:)] My UTM runs HA at home on my single ESXi host because my wife gets grumpy if her tv programs and streaming radio get disrupted. The secondary node allows me to fire off an update and I get at most a few seconds disruption when they swap.
Reply
  • Tom,

    Not everyone has access to vSphere licensing with HA or FT. Essentials Plus (w/ HA) is over $5000, regular vSphere w/ vCenter (w/ FT) is close to $7000. That's not including cost of shared storage. Did this exercise three years ago and vmware plus hardware came to over $30k.

    By comparison, my home server is around $3k, including vSphere Essentials license.

    One corner case where a Active-Passive pair works well on ESX is the single host home use scenario. [:)] My UTM runs HA at home on my single ESXi host because my wife gets grumpy if her tv programs and streaming radio get disrupted. The secondary node allows me to fire off an update and I get at most a few seconds disruption when they swap.
Children
No Data