This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

High Availability - Hot Standby vs. Cluster

Folks,

I'm testing a new build with an ESXi Server running two UTM 9 Nodes. Currently I have it configured in Hot Standby mode and I'm curious if the behavior I'm seeing is accurate. If I were to perform an Up2Date, upon Slave Node completion, should I expect some downtime?

That being said, and if that is expected, does a Cluster scenario ensure 100% uptime?

This thread was automatically locked due to age.

Parents

0 BarryG over 11 years ago

Hi, some of the up2dates with update the AP's firmware (and reboot them); which up2dates did you install?

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 11 years ago

Hi, some of the up2dates with update the AP's firmware (and reboot them); which up2dates did you install?

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 DaMaN841 over 11 years ago in reply to BarryG

Great point, albeit, I'm not sure this was the case. The Up2Date Version was 9.108-23, however, I also tested this behavior by switching the Preferred Master after that installation [:(]
Cancel
Vote Up 0 Vote Down

Cancel