Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't connect to WebAdmin after restoring

I am trying to move my home UTM onto newer hardware, but I'm running into problems after I restore my configuration onto the new box.  The NIC configuration is different, so I know I'm going to have to go in and reconfigure the ports to the new hardware, but the LAN interface is set up on the onboard NIC, which in both cases is a Broadcom 5700-series and comes up as eth0, so I thought I should at least be able to get in to WebAdmin without too much trouble after restoring.

However, after restoring I can ping the LAN interface just fine, but I can no longer access WebAdmin.

Can anyone suggest what I might be missing?


This thread was automatically locked due to age.
Parents
  • I have the same issue, and would prefer not to manually reconfigure rules...

    EDIT: Actually, I just started over and now it's working.

    This time I made sure that I used the same LAN port as the old UTM (eth0)

    I suspect that last time I used eth1 for the LAN side...

Reply
  • I have the same issue, and would prefer not to manually reconfigure rules...

    EDIT: Actually, I just started over and now it's working.

    This time I made sure that I used the same LAN port as the old UTM (eth0)

    I suspect that last time I used eth1 for the LAN side...

Children
No Data