This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM as NUT-client and HA

Hi there,
I configured one UTM as a NUT-slave for two redundant UPS.
Later on I followed the instructions to NOT configure anything on a dedicated HA-slave installation but only switch to "automatic configuration".

Now I am afraid of not having any UPS-Support on the slave-node - but how can I login via ssh into the slave without switching it over to be the master?
It´s a pity that the passive clusternode looses its IP while joining into a HA configuration.

And please SOPHOS: Do make the UPS-configuration and monitoring done via Webadmin and build in there a native support for redundant SNMP devices first instead of legacy SOHO-USB.

Thnx - Chris

This thread was automatically locked due to age.

Parents

0 BarryG over 11 years ago

Hi,
Thanks!

Would configuring the UTM as a NUT master be similar?

I have my home firewall (on bare metal) and a separate dev server (running ESXi) on one UPS; trying to figure out who should be the master.
The only VM that will always be running on ESXi is likely to be FreeNAS (FreeBSD), although I would prefer that ESXi itself be running NUT if possible.

I don't really want to run the UTM on the dev server as there's limited RAM.

Thanks,
Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 11 years ago

Hi,
Thanks!

Would configuring the UTM as a NUT master be similar?

I have my home firewall (on bare metal) and a separate dev server (running ESXi) on one UPS; trying to figure out who should be the master.
The only VM that will always be running on ESXi is likely to be FreeNAS (FreeBSD), although I would prefer that ESXi itself be running NUT if possible.

I don't really want to run the UTM on the dev server as there's limited RAM.

Thanks,
Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data