I recently did a hardware revision upgrade for a client and retired an older ASG320 to my home network. I blew out the HDD so that it acts like a software based appliance instead of a hardware version (and use my home license on it).
My problem is that when i install UTM 9 the NICs are not in the same order as the labels are on the front panel. Eth0 thru Eth3 show up on the physically labeled Eth4-Eth7. Is there a way to change the order either during the install or after?
The NICs that should be Eth4-7 are 10/100 ports and the Eth0-3 are 1000. I would like the 1000 ports to be the eth0-3.
I remember doing this way back when v8 came out but the bookmark i had with the process isn't working any longer. Thanks, Any help would be great.
This thread was automatically locked due to age.
