Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 8 replies
  • Subscribers 2 subscribers
  • Views 1301 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

9.102-8 killed my vlan

yabasoya
This morning I logged into my UTM9 and noticed an update.  I was at 9.101-12 and the update was for 9.102-8.  After upgrading, the UTM rebooted.  After that, my vlan2 no longer works.  Everything else appears to be normal.

eth0 - Ethernet LAN
eth1 - Internet
eth3 - Cisco access point.
          -vlan2 Home network
          -vlan3 Guest network

vlan3 works, vlan2 does not.

I cannot ping anything on vlan2 including the UTM9, but I can ping myself
I do get a valid DHCP address.

I already restored to an earlier date and it still does not work.  Actually, my backup clearly states version 9.101-12 but when I restore, I am still at 9.102-8.

Any suggestions are appreciated.


This thread was automatically locked due to age.
Parents
  • 0
    the backup is only the config not the entire version.  if this a home install?  if not get support involved.  have you tried removing all of the vlans..rebooting..then restoring the backup then rebooting again after 5 minutes?
Reply
  • 0
    the backup is only the config not the entire version.  if this a home install?  if not get support involved.  have you tried removing all of the vlans..rebooting..then restoring the backup then rebooting again after 5 minutes?
Children
No Data