This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Link Error

Hi

I have installed astaro on a new device
Intel board with 4GB ram, 500 GB toshiba HDD, Processor Intel i3 third gen.
Onboard intel Network controller
Two Dlink 520Tx
my default gateway is Intel and has the IP 192.168.1.2
i am able to access the webadmin and configured the two DLink interface with two static Public IP.
Network status shows Up & Error in the dlink Interface.
In interfaces the dlink is shown as Rhine via III
all three connections are from same switch.
configuring the same public ips on a computer connected to same switch works without any issues and i am able to access internet.

What is that i have done wrong.
should i manually install the drivers for dlink provided by manufacturer.

Thanks & Regards

Tony

This thread was automatically locked due to age.

Parents

0 newage over 12 years ago

Hi i dont have Intel cards
Got a little progress
When i ping the IP of Dlink cards from internal i am getting replies
but when i ping the default gateway of dlink request timed out.

Kerala Cochin

I connected two realtek cards on DZ77sl-50k
installed Sophos 9.101 but no internet access.

i am able to ping the IP of THe network card but not its gateway.
i have two motherboards of the same configuration both are having the same issue.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 newage over 12 years ago

Hi i dont have Intel cards
Got a little progress
When i ping the IP of Dlink cards from internal i am getting replies
but when i ping the default gateway of dlink request timed out.

Kerala Cochin

I connected two realtek cards on DZ77sl-50k
installed Sophos 9.101 but no internet access.

i am able to ping the IP of THe network card but not its gateway.
i have two motherboards of the same configuration both are having the same issue.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data