Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 31 replies
  • Subscribers 2 subscribers
  • Views 14350 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Link Error

newage
Hi

I have installed astaro on a new device
Intel board with 4GB ram, 500 GB toshiba HDD, Processor Intel i3 third gen.
Onboard intel Network controller
Two Dlink 520Tx
my default gateway is Intel and has the IP 192.168.1.2
i am able to access the webadmin and configured the two DLink interface with two static Public IP.
Network status shows Up & Error in the dlink Interface.
In interfaces the dlink is shown as Rhine via III
all three connections are from same switch.
configuring the same public ips on a computer connected to same switch works without any issues and i am able to access internet.

What is that i have done wrong.
should i manually install the drivers for dlink provided by manufacturer.

Thanks & Regards

Tony


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to gilipeled
    Hi ,

    What version of UTM. Installed ?
    Can also be a speed issue , try another configuration for sipped instead of auto negotiation .
    Be sure you are using last ver 9.101-12.

    All my best .

    Gilipeled


    UTM Home edition version released before 9.101 
    9.08