I have been running UTM9 on several of our sites for several months now on our sites that are not running Active/Passive HA setups and they seem to be running well. I think we're ready to upgrade our 220 HA to UTM9. What is the recommend process? Will the one-touch upgrade just run or is there a special dance we need to do to get it right? I'm envisioning it being simple like this: Trigger One-Touch Upgrade on HA Master HA Master Updates and Reboots HA Slave Fails Over While HA Master Boots HA Slave Upgrades to UTM9 and Reboots, completing upgrade HA Master becomes primary again during failover from HA Slave It sounds good on paper, but my gut tells me that there is more to it. I have seen in some early threads from late 2012 where one of the units had to be shut down but I'm wondering if that is correct or if that's still needed. If this was covered somewhere else and I missed it, please direct me where this is laid out. Thanks in advance.

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

v8.309 -> UTM9 220 Active/Passive HA Upgrade Process

I have been running UTM9 on several of our sites for several months now on our sites that are not running Active/Passive HA setups and they seem to be running well. I think we're ready to upgrade our 220 HA to UTM9.

What is the recommend process? Will the one-touch upgrade just run or is there a special dance we need to do to get it right?

I'm envisioning it being simple like this:

Trigger One-Touch Upgrade on HA Master
HA Master Updates and Reboots
HA Slave Fails Over While HA Master Boots
HA Slave Upgrades to UTM9 and Reboots, completing upgrade
HA Master becomes primary again during failover from HA Slave

It sounds good on paper, but my gut tells me that there is more to it. I have seen in some early threads from late 2012 where one of the units had to be shut down but I'm wondering if that is correct or if that's still needed.

If this was covered somewhere else and I missed it, please direct me where this is laid out.

Thanks in advance.

This thread was automatically locked due to age.

Parents

0 BAlfson over 12 years ago

Here's what I remember:

During the update of the Slave, you will see "Update" in 'Management >> High Availability'. You will lose contact with WebAdmin after the Slave becomes the new Master. Logging back in to WebAdmin, you will see the new Slave updating and then being synced to.

Looking forward to a report from someone that's not digging into six-week-old memories. [;)]

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 12 years ago

Here's what I remember:

During the update of the Slave, you will see "Update" in 'Management >> High Availability'. You will lose contact with WebAdmin after the Slave becomes the new Master. Logging back in to WebAdmin, you will see the new Slave updating and then being synced to.

Looking forward to a report from someone that's not digging into six-week-old memories. [;)]

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data