Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 8 replies
  • Subscribers 2 subscribers
  • Views 2372 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

New install of UTM 9 - Unable to get traffic inside --> outside

howiecamp
I've just completed a fresh install of UTM 9.  I followed the wizard during the install and specified the IP address configuration of both the internal and external interfaces.  I enabled ICMP response on both interfaces.

I am able to ping the internal interface from the inside network and the external interface from the Internet side.  I am also able to ping hosts on both the internal network and the Internet from the appliance itself when I'm SSH'd in.

With the exception of the ICMP changes I made, the appliance has whatever set of firewall/traffic rules are default.

I am *not* however able to ping Internet hosts from the inside network through the UTM or access any other ports eg. http/80.  The firewall rules I am looking at do not appear to be blocking this.  The host I am originating the traffic from of course has the UTM set as it's default gateway.


This thread was automatically locked due to age.
Parents
  • 0
    hi Barry will do.  I think I know what went wrong during setup.  There was some confusion and screwing around with which physical interface corresponded to inside and outside, and some configuration changes were incorrectly made.  I am going to do a fresh install with these learnings.

    Thank you.
Reply
  • 0
    hi Barry will do.  I think I know what went wrong during setup.  There was some confusion and screwing around with which physical interface corresponded to inside and outside, and some configuration changes were incorrectly made.  I am going to do a fresh install with these learnings.

    Thank you.
Children
No Data
Cookie Information Banner