This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Utm220 ha

Hey guys.. for active passive HA.. do you preconfigure the passive UTM with the same interface\IP as the active info before enabling HA and plugging up eth3?

This thread was automatically locked due to age.

Parents

0 AngeloC over 12 years ago

You can indeed, from the notifications page distable the notifications for HA, and it will show unlinked on the status page but you could live with that.

Really for installations with HA and one ISP put a little switch and run one to each external interface, its kind of the point of HA [:)]
Cancel
Vote Up 0 Vote Down

Cancel
0 tuscani over 12 years ago in reply to AngeloC

Ok will do.. I just had to put a single point of failure in front of two HA devices.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 tuscani over 12 years ago in reply to AngeloC

Ok will do.. I just had to put a single point of failure in front of two HA devices.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data