This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bricked 120?

Hi

I stated up my 120 for the first time. It says that it should make 5 beeps, but the system never makes a sound. Ive tried to connect to the web interface but it's unable to connect. How long does it take for the system to boot before hearing any sounds?

Ive set up 2 220s before with no problem.

Any ideas?

This thread was automatically locked due to age.

0 BarryG over 13 years ago

Could be; You should probably open a support ticket with your reseller or Astaro.

Does it have a VGA port, or do you have a serial terminal you could connect?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 NewImage over 13 years ago in reply to BarryG

Called up Sophos, turns out it was shipped without the Firmware burned on it. So made a CD, Hooked up a USB CD drive and it started installing off the disk.
Cancel
Vote Up 0 Vote Down

Cancel
0 NewImage over 13 years ago

After installing the software, it only detects 3 of the 4 Eth ports. Eth3 is not detected.

Any ideas?
Cancel
Vote Up 0 Vote Down

Cancel
0 NewImage over 13 years ago

Never Mind, HA was turned on and was using the port
Cancel
Vote Up 0 Vote Down

Cancel