Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 13 replies
  • Subscribers 2 subscribers
  • Views 3226 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can´t install UTM9 on ASG120 rev4

3NDL3R
I tried to install the new UTM9 on my ASG120 rev.4 and got the following error:

"[   1.257671] drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
INIT: version 2.06 booting"

Installing it with "classic" mode works w/o any problems until installing the system. 

Then it aborts w/ the error that it couldn´t found a specific file/image on the CD-R.

Installing the old Astaro v8.301 worked w/o problems. Later v8 has the same error.

Does anyboday knows how to get rid of this error and installing a fresh UTM 9 on it?


This thread was automatically locked due to age.
Parents Reply
  • 0 in reply to Scott_Klassen
    We just posted a new ISO this morning, 9.003.  ftp://ftp.astaro.de/UTM/v9/hardware_appliance/iso/

    After downloading, check the MD5 sum.  When you burn it to disk, do so no faster than 8x.  Report back the results.


    i've not had a problem burning at 20+x.  It's all in your media and maybe the drive.  It also helps i don't run anti-crud on my machine either.  sometimes the anti-crud causes problems when burning.  If your system isn't loaded down with a whole bunch of stuff running in the background and you are using good media then high-speed burning is just fine.

    Owner:  Emmanuel Technology Consulting

    http://etc-md.com

    Former Sophos SG(Astaro) advocate/researcher/Silver Partner

    PfSense w/Suricata, ntopng, 

    Other addons to follow

Children
No Data
Cookie Information Banner