This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Enabling VLAN Breaks LAN Traffic to Linksys Switch

Hi
I'm trying to setup a new Astaro firewall, but I've run into problems trying to setup VLAN'S
I'm running the software on a HP Microserver connected to a Linksys SRW2024 (Port in General mode) but as soon as I change the default LAN to VLAN No.1 all connections to Astaro breaks and the only way to get back into the webadmin is to re-install the softwre.
Oddly enough, the WebAdmin is enabled for the WAN connection, but connection is also a no go through there.
I've come a full stop here as I would love to drop the new firewall in, but without the segregated internal networks, Its no good.

Kind Regards
Dave

This thread was automatically locked due to age.

Parents

0 BAlfson over 13 years ago

If you're able to login as root at the console, you can change the IP with ifconfig. You should immediately login to WebAdmin and change the IP in WebAdmin to the one you specified with ifconfig.

You're definitely going to want to confirm you can login to the WAN interface before you setup the Internal interface with VLANs.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 13 years ago

If you're able to login as root at the console, you can change the IP with ifconfig. You should immediately login to WebAdmin and change the IP in WebAdmin to the one you specified with ifconfig.

You're definitely going to want to confirm you can login to the WAN interface before you setup the Internal interface with VLANs.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data