This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Enabling VLAN Breaks LAN Traffic to Linksys Switch

Hi
I'm trying to setup a new Astaro firewall, but I've run into problems trying to setup VLAN'S
I'm running the software on a HP Microserver connected to a Linksys SRW2024 (Port in General mode) but as soon as I change the default LAN to VLAN No.1 all connections to Astaro breaks and the only way to get back into the webadmin is to re-install the softwre.
Oddly enough, the WebAdmin is enabled for the WAN connection, but connection is also a no go through there.
I've come a full stop here as I would love to drop the new firewall in, but without the segregated internal networks, Its no good.

Kind Regards
Dave

This thread was automatically locked due to age.

Parents

0 BarryG over 13 years ago

Hi, you'll need to be using webadmin from a different interface before you modify your LAN interface.
e.g. get connected on the WAN interface.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 13 years ago

Hi, you'll need to be using webadmin from a different interface before you modify your LAN interface.
e.g. get connected on the WAN interface.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data