This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unusual Install Message

All-

I received the enclosed notification when installing UTM 9.000-8.1 from the downloaded ISO. UTM 9 is being installed on a lenovo core 2 duo with 8 gb of ram, running on an mtron 60 gb ssd (SLC). There has been no issue installing any other versions of ASG. Secondly I have down loaded and burned 2 different CD's to make sure it was not the CD. The notification is as follows:

Boot:
[ 0.623649] drivers/rtc/hctosys.c: unable to open rtc device (rtc8)
INIT: version 2.86 booting

I see this message after pressing enter when booting from the CD. Not sure what this indicates but I seem to have normal operation with the ASG post install.....

Thanks,
Jim

This thread was automatically locked due to age.

Parents

0 pbrdodk101 over 13 years ago

hmmm. looking at, say, Linux/drivers/rtc/hctosys.c shows that this is likely to be a configuration issue and not a path problem (this code hasn't changed for a while). The RTC device is used to (re)initialize the system clock (usually it is the rtc0 device) so that is why it doesn't matter in the long run. the "8" in rtc8 puzzles me a little...

over to sophos and someone with more linux knowledge.
Cancel
Vote Up 0 Vote Down

Cancel
0 scottj_01 over 13 years ago in reply to pbrdodk101

Pbrdodk101,

I should have been more in tune with your first post. It looks like you may be correct. However it is odd this is the first time I have seen it on ASG. Hopefully it is corrected in addition to the other RPM issue.

Thanks,
Jim
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 scottj_01 over 13 years ago in reply to pbrdodk101

Pbrdodk101,

I should have been more in tune with your first post. It looks like you may be correct. However it is odd this is the first time I have seen it on ASG. Hopefully it is corrected in addition to the other RPM issue.

Thanks,
Jim
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data