This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unusual Install Message

All-

I received the enclosed notification when installing UTM 9.000-8.1 from the downloaded ISO. UTM 9 is being installed on a lenovo core 2 duo with 8 gb of ram, running on an mtron 60 gb ssd (SLC). There has been no issue installing any other versions of ASG. Secondly I have down loaded and burned 2 different CD's to make sure it was not the CD. The notification is as follows:

Boot:
[     0.623649] drivers/rtc/hctosys.c:  unable to open rtc device (rtc8) 
INIT:   version 2.86 booting

I see this message after pressing enter when booting from the CD. Not sure what this indicates but I seem to have normal operation with the ASG post install..... 

Thanks,
Jim


This thread was automatically locked due to age.
Parents
  • I also recieved this error message during install.

    But i installed it in a Hyper-V vmby mounting the iso file directly without burning it.
    So this error does not appear because of the overlenght .rpm filepath.
Reply
  • I also recieved this error message during install.

    But i installed it in a Hyper-V vmby mounting the iso file directly without burning it.
    So this error does not appear because of the overlenght .rpm filepath.
Children
  • Albeck,

    I think the two possibly may be tied together. This could go either way. One item is certain, something in the initial start of the CD cannot be found. Secondly there may be an issue with the length of a file name/path. While the two could be seperate I am thinking they are associated. The key here is to have the Astaro engineer who compiled the ISO take a look at the installer verifing all of the steps. This is inclusive of path length and file name/path. 

    Thanks,
    Jim