This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Rev 5 Appliance Won't Downgrade to 8.103

Trying to set up a new 320 Rev 5, that came shipped with 8.302. We've had all sorts of problems with the web proxy in 8.3x, so we want to backdate to 8.103. 

Yet, booting with the CD, the installation fails. Actually, it won't even get as far as installing. 

Is this by design, or has anyone else seen this?


This thread was automatically locked due to age.
Parents
  • Your probably falling afoul of the hardware checks.  There are scripts in the hardware install ISO that check for specific hardware in appliances.  Rev 5 hardware has some major upgrades in terms of the hardware in systems, but this will cause failures in older install scripts as it won't recognize some of the new hardware as acceptable (rev 5 didn't exist when 8.103 was released, many moons ago).

    As Williams says, install 8.305, then open up a support case to get your AD auth issue resolved.
    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
Reply
  • Your probably falling afoul of the hardware checks.  There are scripts in the hardware install ISO that check for specific hardware in appliances.  Rev 5 hardware has some major upgrades in terms of the hardware in systems, but this will cause failures in older install scripts as it won't recognize some of the new hardware as acceptable (rev 5 didn't exist when 8.103 was released, many moons ago).

    As Williams says, install 8.305, then open up a support case to get your AD auth issue resolved.
    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
Children
No Data