This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

High Availability Notifiers?

I have a customer who has set up two units in High Availability. Is it usual to show one as being UNLINKED?

Please see the attached scr-shot.

Unlinked.png

Thanks,

JB

This thread was automatically locked due to age.

Parents

0 BAlfson over 13 years ago

One of the interfaces isn't connected. If the Dashboard shows that the sync interface is connected, then it must be one of the others on the Slave.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 Buggrit over 13 years ago in reply to BAlfson

Thanks Bob,

What can be done about this? How should a proper connection be achieved? I'm asking this as I'm not on site and cannot see how the customer has set their system up. It would be great if I can get back to them with a sensible solution to the issue.

Regards JB
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Buggrit over 13 years ago in reply to BAlfson

Thanks Bob,

What can be done about this? How should a proper connection be achieved? I'm asking this as I'm not on site and cannot see how the customer has set their system up. It would be great if I can get back to them with a sensible solution to the issue.

Regards JB
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data