This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Need Help with multipathing

Hi All,

I am a newbie to Astaro UTM - i would like to setup the firewall with the following rules, please help me

We have two ISP configured on two ports (Eth1 and Eth2) our Lan network (Internal users) are on Eth0

I have setup multipathing to allow a set of specific users(Created a group) on Eth2, i want all the remaining users to go through Eth1.

Currently it load balances between the two ISP

Please suggest.

Reg,
Darshan

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 13 years ago

In Uplink Balancing, ensure that eth1 is the top entry in the Active Interfaces list. Give eth2 a weight of 0. Then create your Multipath Rules to send specific traffic over eth2.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 13 years ago

In Uplink Balancing, ensure that eth1 is the top entry in the Active Interfaces list. Give eth2 a weight of 0. Then create your Multipath Rules to send specific traffic over eth2.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data