This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Virtual IP or fysical interface?

Hi you all,

We have multiple public IP addresses and are migrating soon from an MS ISA server to Astaro ASG220.
On the WAN side we have now 2 IP addresses with on both tcp port 80 (http) and 443 (https) in use (DNAT).

How do you set this up in Astaro?
Do you use multiple interfaces (I persume not)?
Where/how do you configure for the second IP adres the portforwards if its an virtual IP address.

I did browse the forum a bit bud could not find a answer.
Any help or link is welcome.

Kind regards,

Rico

This thread was automatically locked due to age.

Parents

0 BAlfson over 13 years ago

Hi, Rico, and welcome to the User BB!

Look on the 'Additional Addresses' tab of 'Interfaces'. If you have your own mail server, we normally configure the Astaro with a hostname of your current MX record, and configure the DNATed public IPs as Additional Addresses. It's probably worth a few hundred Euros to have a nearby, experienced Astaro engineer guide you with the initial configuration.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 13 years ago

Hi, Rico, and welcome to the User BB!

Look on the 'Additional Addresses' tab of 'Interfaces'. If you have your own mail server, we normally configure the Astaro with a hostname of your current MX record, and configure the DNATed public IPs as Additional Addresses. It's probably worth a few hundred Euros to have a nearby, experienced Astaro engineer guide you with the initial configuration.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data