This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

64-bit installation

I bought a new Jetway motherboard JNC9KDL-2700-LF with the Intel Cedar Trail D2700 CPU and 4 GB of RAM, which runs fine and supports VLAN on the two Gigabit-Nics.
But it only take 3 GB because it's a 32bit installation.
I tried to install several times, but never came to the question to install the 64bit version. The Intel specification for the D2700 tell, it's 64 Bit.

Where is the problem to use the full 4 GB of RAM?

This thread was automatically locked due to age.

Parents

0 wk_03 over 13 years ago

I try V8.300. Looking in the BIOS is a good hint. I'll try that.
Cancel
Vote Up 0 Vote Down

Cancel
0 wk_03 over 13 years ago in reply to wk_03

Just looked at the BIOS. Found nothing to activate 64bit.

There is one note in 'CPU Configuration': "EMT64 Not supported".
Is this relevant?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 wk_03 over 13 years ago in reply to wk_03

Just looked at the BIOS. Found nothing to activate 64bit.

There is one note in 'CPU Configuration': "EMT64 Not supported".
Is this relevant?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 William Warren over 13 years ago in reply to wk_03

Just looked at the BIOS. Found nothing to activate 64bit.

There is one note in 'CPU Configuration': "EMT64 Not supported".
Is this relevant?

yeppers that means 64 bit support is not available on that board..the cpu has it but apparently the board does not.

Owner: Emmanuel Technology Consulting

http://etc-md.com

Former Sophos SG(Astaro) advocate/researcher/Silver Partner

PfSense w/Suricata, ntopng,

Other addons to follow
Cancel
Vote Up 0 Vote Down

Cancel