Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 9 replies
  • Subscribers 2 subscribers
  • Views 1951 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Wireless zones on APs

Bob DuBois
Hello,

I have successfully created an internal and external zone for my AP's.  What I can't yet get working is preventing my guest network to not access internal IP's.  I have it set to Seperate Zone.  It gets my guest IP range, however, it can still ping internal network.

What am I missing here.

Thank you.


This thread was automatically locked due to age.
Parents
  • 0
    You might also consider making a packet filter rule that says "from Guest Wireless Network to INTERNET = allow" instead of the usual "any" destination that some set. This will then give them Internet visibility without the local LANs being included. 

    For increased separation, you can also enable the client isolation feature to separate clients on the Guest Wireless Network from being able to "see" each other as well.
Reply
  • 0
    You might also consider making a packet filter rule that says "from Guest Wireless Network to INTERNET = allow" instead of the usual "any" destination that some set. This will then give them Internet visibility without the local LANs being included. 

    For increased separation, you can also enable the client isolation feature to separate clients on the Guest Wireless Network from being able to "see" each other as well.
Children
Cookie Information Banner