This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Asg 120 a v7 cmd line repair

I'm logged in to the asg console and I am at the command line. This is a testing situation so I'm not concerned about data on the device. It says that there is some directory corruption and I should repair the disk. What is the proper command to do that? I tried chkdsk /f but it didn't recognize it.

This thread was automatically locked due to age.

Parents

0 mrmyth over 13 years ago

I ran the same commands again and it says problem in HTREE directory mode 166463 over an over then stops and says Unexpected inconsistency run fsck manually without -a or -p options
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 mrmyth over 13 years ago

I ran the same commands again and it says problem in HTREE directory mode 166463 over an over then stops and says Unexpected inconsistency run fsck manually without -a or -p options
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 BrucekConvergent over 13 years ago in reply to mrmyth

I would just start over -- but I would run a hard disk testing tool first -- the HD mfg. normally has tools that will check a HD's health.

CTO, Convergent Information Security Solutions, LLC

https://www.convergesecurity.com

Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries. Use the advice given at your own risk.
Cancel
Vote Up 0 Vote Down

Cancel