Hi, I am new to the forum but have used ASG since 2004 without major issues.
I am upgrqading my current system to a J&W Minix uITX Mobo with dual Broadcom 57788 NICs.
ASG 802 does not recognise the NICs although the tg3 driver is there.
relevant dmesg output is:
Relevant dmesg output
4.915648] tg3.c:v3.102 (September 1, 2009)
[ 4.915707] tg3 0000:04:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 4.915759] tg3 0000:04:00.0: setting latency timer to 64
[ 4.917984] tg3 mdio bus: probed
[ 4.918035] eth%d: No PHY devices
[ 4.918104] tg3: Problem fetching invariants of chip, aborting.
[ 4.918158] tg3 0000:04:00.0: PCI INT A disabled
[ 4.918216] tg3 0000:05:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
[ 4.918268] tg3 0000:05:00.0: setting latency timer to 64
[ 4.920985] tg3 mdio bus: probed
[ 4.921035] eth%d: No PHY devices
[ 4.921101] tg3: Problem fetching invariants of chip, aborting.
[ 4.921154] tg3 0000:05:00.0: PCI INT A disabled
[ 4.955157] e1000e 0000:02:00.0: eth0: (PCI Express:2.5GT/s:Width x4) 00:1b:21:c1:65:42
[ 4.955214] e1000e 0000:02:00.0: eth0: Intel(R) PRO/1000 Network Connection
[ 4.955339] e1000e 0000:02:00.0: eth0: MAC: 1, PHY: 4, PBA No: D50868-007
[ 4.955392] e1000e 0000:02:00.1: Disabling ASPM L1
[ 4.955456] e1000e 0000:02:00.1: PCI INT B -> GSI 19 (level, low) -> IRQ 19
[ 4.955517] e1000e 0000:02:00.1: setting latency timer to 64
[ 4.955593] e1000e 0000:02:00.1: irq 30 for MSI/MSI-X
Has anyone else encountered this issue and is there any way to easily resolve this. I have the tge3-3.116j.tar.gz file but with the distro there is no build capability.
I've attached output that may be useful - modprobe, lspci, ifconfig etc.
Thanks
This thread was automatically locked due to age.
