This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Restore backup from 8.103 to 8.201

Ok, so in my other post, I mentioned that I couldn't get the system to run up2date successfully after adding my settings, so I thought I'd restore from backup of 8.103. Did a fresh install of ASG, got to the wizard asking to restore from backup, and it goes and sits there like it's trying to upload the backup file, then after about 10 minutes, it comes back and says "BAD REQUEST" and doesn't upload the file..

Is there an issue restoring a backup that was done in 8.103?

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 14 years ago

I just tried this on my test box and it worked fine. 8.103 backup onto an 8.201 install. Let's try this: Get through the initial setup wizard as quickly as possible, but do not upload the backup yet. Get into WebAdmin, then wait for the post-installs stuff to settle down a bit (you'll know when the CPU settles down). Then go to Management>>Backup/Restore and upload and restore your backup from here.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 14 years ago

I just tried this on my test box and it worked fine. 8.103 backup onto an 8.201 install. Let's try this: Get through the initial setup wizard as quickly as possible, but do not upload the backup yet. Get into WebAdmin, then wait for the post-installs stuff to settle down a bit (you'll know when the CPU settles down). Then go to Management>>Backup/Restore and upload and restore your backup from here.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data