This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Accidentally applied the wrong u2d package.

[:$] I think I goofed big time. I downloaded the u2d-sys-8.200 soft release package, and manually imported it last night. When I uploaded it, I accidentally picked the u2d-sys-8.174-200 package that I previously downloaded for a test box instead of the full u2d-sys-8.200 one. I had already applied it before I realized it was the wrong one. u2d showed 8.2 as available and "looked" like it applied it, but when I checked afterwards, it didn't update anything, and the version was still 8.103.
I tried again with the full 8.200 package, and now it doesn't even show up as available on the overview tab.

Any ideas?

Thanks,
Adam

This thread was automatically locked due to age.

0 Scott_Klassen over 14 years ago

You'll need to remove the wrong one first. It will be stored in /var/up2date/sys. If it were me, at this point in time, I'd just wait until the GA (final) of 8.200 is released.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 addrockk over 14 years ago

OK, Thanks. I was just worried that there was no easy way to "go back" or that I had botched the system by feeding it a bad update.
Cancel
Vote Up 0 Vote Down

Cancel