This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG virtual appliance and ADSL modem in bridge mode

I'm trying to configure an ASG virtual appliance in my home lab with an ADSL modem in bridge mode. I am in New Zealand and the ADSL here is all PPPoA so the DSL modem has to do the login. With the modem in bridge mode this shouldn't be a problem. On the ASG appliance I get a WAN IP address 118.93.42.146 but no gateway is assigned by the DSL modem. I have been using the DSL connection this way with an Airport Extreme and it works fine. In fact if I hook up the ASG to the LAN side of the Airport Extreme the ASG works fine as well but then I have a double NAT configuration. Is there some configuration I'm missing on the ASG? It simply doesn't have a default route. I have checked the box on the WAN interface of the ASG to make it the default gateway. When I do that the default gateway on the WAN interface shows as the same IP as the WAN interface. I've also checked the box in the Advanced section of the WAN interface to Proxy ARP but still no traffic flows out the WAN interface.

The ARP table on the DSL modem shows the ASG WAN MAC address correctly. I know that no traffic is flowing to the DSL modem from the ASG because the ARP table on the DSL modem gets populated when the ASG broadcasts for a DHCP provided WAN address. After 10 min or so the ARP entry expires and drops out of the ARP table on the DSL modem. If I tell the ASG to renew the DHCP on the WAN interface the ARP entry reappears. If the ASG was sending any traffic out the WAN interface the ARP entry would never disappear.

Any ideas would be greatly appreciated.

Cheers,
Jason


This thread was automatically locked due to age.
Parents
  • You can try to put the gateway address you see.in airport express in asg manually.

    The ppoa login can also be done by asg. You just have to leave the modem as modem in bridgedmode. Without login.
  • Hi Karabela thanks for the reply. The Airport Extreme gateway is the same IP address that it gets via DHCP which is different than what the ASG gets but the ASG also uses the IP it gets via DHCP as it's gateway.

    In New Zealand the ADSL connections do not support a pass through PPPoA login so the modem actually runs in what is called a half bridge mode. The ISP does not pass out a default gateway in this configuration because the modem knows inherently how to direct traffic from the ethernet interface outbound. The issue seems to be that the ASG won't forward all unknown traffic out the WAN interface without knowing where it is sending it. I'm not entirely sure but that's what it seems like. I'm open to suggestions as to how to get the ASG to forward all traffic not bound for a LAN subnet to the WAN interface. Without a default gateway I just don't know how to tell the ASG to do this.

    Jason
Reply
  • Hi Karabela thanks for the reply. The Airport Extreme gateway is the same IP address that it gets via DHCP which is different than what the ASG gets but the ASG also uses the IP it gets via DHCP as it's gateway.

    In New Zealand the ADSL connections do not support a pass through PPPoA login so the modem actually runs in what is called a half bridge mode. The ISP does not pass out a default gateway in this configuration because the modem knows inherently how to direct traffic from the ethernet interface outbound. The issue seems to be that the ASG won't forward all unknown traffic out the WAN interface without knowing where it is sending it. I'm not entirely sure but that's what it seems like. I'm open to suggestions as to how to get the ASG to forward all traffic not bound for a LAN subnet to the WAN interface. Without a default gateway I just don't know how to tell the ASG to do this.

    Jason
Children
No Data