This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Exclude Interface from Initiate a failover

Hello,

is it possible to exclude a Interface from initiate a HA failover?

We have 2 Uplink Interfaces, one of them is VDSL, anytime if the link to the DSL-Modem fails, the firewall switch to the slave. this is unnessesary because of two uplinks.

Can i change this behavior?

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 14 years ago

Ok then. I'm not finding a way to do this for V7. Maybe make plans to update to 8.10x at the next opportunity to get this ability.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 14 years ago

Ok then. I'm not finding a way to do this for V7. Maybe make plans to update to 8.10x at the next opportunity to get this ability.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data