This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Hi just installed astaro gateway v8

Hi

I've searched, here but I cannot find my answer. Today I've installed astaro, the ip is 192.168.1.1(:4444 and https)

How to log into webadmin part? Does have to be connected to my home network? Remove my linksys, and set the pc there instead?

Eth0 card, I recon is the card that built in the computer, got two other pci card installed.

Please help


This thread was automatically locked due to age.
Parents
  • Yep, at least two.  [:)]  In the linux world (not just Astaro), eth0 would be your WAN interface (the one going out to the internet, in your case homecentral).  eth1 would be for your LAN (stuff internal to your network).  Any additional eth interfaces could be used for additional internal networks or WAN connections.  Right now what you want is whichever NIC is eth1 to connect to your switch.  You'll also want the laptop that you'll be using to connect to WebAdmin connected to this same switch.  The tricky thing is figuring out which NIC is assigned which interface.  If you weren't paying close attention in assigning WebAdmin to eth1 and which NIC is eth1 during install, it's pure guesswork at this point.  You can always reinstall, carefully watching for these things, which isn't a big deal since install only takes 10-15 minutes in most cases.

    PS, Lutefisk is icky.  ;P
    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
  • Hi again

    I'm re installing againg, got spotfy running and a big cup of coffee [[:)]] I've never tasted lutefisk, but I do agree with you anyway [;)]

    I dont give up quite just yet [[:)]]
Reply Children
No Data