This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG V8 reboot needed after link down

Hello,

My experience with questions I raised been good [:)], so I will try again!

I am connected to the internet via a Cable Modem. The ISP I am using is not the best, but we are forced to use him. Recently he got problems in his net that causes the modem to reboot quite often, after each re-boot of the Modem I am forced to reboot the ASG as well! 
I find this a bit strange, I assumed when the link is back up even if after error then ASG would simple just restore the connection. I have tried under interfaces to do the renew of the lease, but don't help only way is to hit the re-set button under Shutdown/Restart. After the modem is back up in Dashboard > Interface State is = up, Link = Error.
I have tried to find thru log what the Error could mean. but I don't find any information about the Interfaces - perhaps I look the wrong places?

Best Regards - Steen


This thread was automatically locked due to age.
Parents
  • Hi Moto!
    Many thanks for the command and the link. [:)]
    I will try the next time I have the "dead" connection to give the command.
    Can I assume the command is like release / renew of the DHCP given by my ISP?
    If it is then you know why this command got a different effect than the "renew" command found under Interfaces (red/wan)? [:S]

    Many thanks - Steen
Reply
  • Hi Moto!
    Many thanks for the command and the link. [:)]
    I will try the next time I have the "dead" connection to give the command.
    Can I assume the command is like release / renew of the DHCP given by my ISP?
    If it is then you know why this command got a different effect than the "renew" command found under Interfaces (red/wan)? [:S]

    Many thanks - Steen
Children
No Data