This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

High memory/swap usage (v8.102)

Hi,

Installed an Astaro ASG 425 HA Cluster (Active/Passive) 2 months ago, only enabled Web and Mail Security. Upgraded the appliances with the latest stable release v8.102.

After a few weeks I've noticed the memory and swap usage increased over time. Even at non-working hours. Using the 'top' command at the CLI I've noticed that the HTTP Proxy proces was using 70% of the total memory. I've stopped and started the HTTP proxy service last friday night because the swap and memory usage was about 100%.

After restarting the HTTP proxy service the swap/memory usage dropped back to 20% (memory) 0% (swap). Yesterday I saw the usage increasing again.. Seems like a memory leak to me?

I've attached the CPU/Memory/Partition usage statistics.

(Network Security and IPS is disabled)

This thread was automatically locked due to age.

0 cybermuz over 14 years ago

How much memory do you have? and did you enable the Local Content Filter Signature Caching?
Cancel
Vote Up 0 Vote Down

Cancel
0 roos10 over 14 years ago in reply to cybermuz

HTTP(S) Caching is turned off.

Capacity:
Memory 3.2 GB
Swap 1.0 GB
Cancel
Vote Up 0 Vote Down

Cancel
0 roos10 over 14 years ago in reply to roos10

Contacted Astaro support, it's a known issue with the AD auth deamon.

Going to be patched.
Cancel
Vote Up 0 Vote Down

Cancel