This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Passing Client IP to IIS

I had asked this before, and didn't get much response.. however digging into v8, it shows that the system has to be in bridge mode to get full transparent mode.. which doesn't help things much.  So is this the only way I'd be able to get the client-ip info from the client to IIS, or is there a way in Astaro to setup an HTTP header with the client-ip info forwarded?  Or am I asking too much? [;)] I would think every other firewall can do this.. pass the client ip.. I would think Astaro could do this.. or if there's a way to run the full transparent mode without being in bridged mode..??


This thread was automatically locked due to age.
Parents
  • I'm still not sure I understand what you're doing now - I guess you're using the Web Application Firewall Reverse Proxy.  I don't think there's a full-transparent setting for that at present, nor do I understand how there could be.  You might want to make a feature request: Astaro Gateway Feature Requests

    If you just use a DNAT, skipping the WAF, your webserver will see the public IP.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • I'm still not sure I understand what you're doing now - I guess you're using the Web Application Firewall Reverse Proxy.  I don't think there's a full-transparent setting for that at present, nor do I understand how there could be.  You might want to make a feature request: Astaro Gateway Feature Requests

    If you just use a DNAT, skipping the WAF, your webserver will see the public IP.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data