This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Install of ASG 8 fails on HP ML350 G3 and DL360 G3

Yesterday I tried to update an existing ASG 7.505 to v8 by using the downloaded ISO image. Install works fine, all devices detected, no errors.

However, upon first reboot the server will reset itself or simply hang while loading the GRUB loader from the MBR. Not even an error message from GRUB appears.

I tried twice in different servers, but same effect. Is this a known issue?

Thanks,

Ronny

This thread was automatically locked due to age.

Parents

0 Alvin over 15 years ago

I would be installing to my HP ML110 Server later today and update you all.

But I am kind of worried when I saw this 32bit and 64bit?

I seriously do not know my 4 year old server but I assume during installation the thing will know what to install?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Alvin over 15 years ago

I would be installing to my HP ML110 Server later today and update you all.

But I am kind of worried when I saw this 32bit and 64bit?

I seriously do not know my 4 year old server but I assume during installation the thing will know what to install?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 rbremer over 15 years ago in reply to Alvin

I would be installing to my HP ML110 Server later today and update you all.

But I am kind of worried when I saw this 32bit and 64bit?

I seriously do not know my 4 year old server but I assume during installation the thing will know what to install?

From the packages being installed I assume both 32 and 64 bit kernels and rpms are installed side by side. But that is just my observation, as I haven't been able to boot into the installed system.

A 4 year old server should be 64 bit, the G3 we are talking about here are more like 5+.

Ronny
Cancel
Vote Up 0 Vote Down

Cancel