This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Adding a 3rd nic and then system error

Hi,


I have a server with astaro access gateway v7.504 installed. Lovely!! 

I added a 3rd nic,  a old nic. Now  eth0 eth1 and eth2(new) installed.

1st state up and link up
2nd state up and link down
3rd state up and link up


When I added the 3rd one, 2nd links went down. 3rd has no wire attached yet. 1st and 2nd yes.

If I remove 3rd, system works fine. All of them have differents ips address.

Is this last nic bad?

Best regards


This thread was automatically locked due to age.
Parents
  • Yes... use Astaro's built-in backup system; then you can put the backup file on a USB 'thumb-drive' and plug it in to the new system and it'll automatically restore.

    Barry
  • I added this 3rd nic because a AP wireless is going to be connected  for free internet browsing for lunch time workers.


    Is possible to set timetable for connections? I did not see this option.


    Best regards
  • Hi,
    most certainly is. Do wish to use the proxy of the packet filter for lunch browsers.
    PF rules setup a time definition.
    Enable a packet filter rule with the time definition for the new network.
    You will of course need a masq rule, add it to the dns and ntp use groups.

    It is a simple as that.

    Ian M
Reply
  • Hi,
    most certainly is. Do wish to use the proxy of the packet filter for lunch browsers.
    PF rules setup a time definition.
    Enable a packet filter rule with the time definition for the new network.
    You will of course need a masq rule, add it to the dns and ntp use groups.

    It is a simple as that.

    Ian M
Children