Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 10 replies
  • Subscribers 2 subscribers
  • Views 537 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Adding a 3rd nic and then system error

equintana
Hi,


I have a server with astaro access gateway v7.504 installed. Lovely!! 

I added a 3rd nic,  a old nic. Now  eth0 eth1 and eth2(new) installed.

1st state up and link up
2nd state up and link down
3rd state up and link up


When I added the 3rd one, 2nd links went down. 3rd has no wire attached yet. 1st and 2nd yes.

If I remove 3rd, system works fine. All of them have differents ips address.

Is this last nic bad?

Best regards


This thread was automatically locked due to age.
Parents
  • 0
    Not necessarily...  When you install Astaro from a CD, the installer only loads drivers for the devices installed - this is not a plug-and-play system.  In my experience, if you add a NIC that's identical to one of the existing ones, the system will adapt.  If you add, like you did, one that's different, you must re-install to obtain proper function.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0
    Not necessarily...  When you install Astaro from a CD, the installer only loads drivers for the devices installed - this is not a plug-and-play system.  In my experience, if you add a NIC that's identical to one of the existing ones, the system will adapt.  If you add, like you did, one that's different, you must re-install to obtain proper function.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data
Cookie Information Banner