This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

cannot load webadmin url

Install went successful, set my ip address to 192.168.2.100, it said to reboot and plug a wire from router/switch to the management port I set to (eth0, I have 5 nics total in the box, all worked before I installed astaro) and then go to:

https://192.168.2.100:4444

Page will not load, no self signed cert errors.

This happens on Firefox, Safari on a Mac. IE/Firefox on Windows. Wired and wireless (everything is on same subnet (.2)). Tried plugging into another nic on the box that didn't work, tried plugging into eth0 that didn't work

ifconfig shows eth0 is up and has 192.168.2.100 as an IP address

This thread was automatically locked due to age.

Parents

0 UrsWeiss over 16 years ago

Maybe dumb question, but:

Have you tried all five NIC's of the box? Maybe eth0 is not the one you think it should be.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 UrsWeiss over 16 years ago

Maybe dumb question, but:

Have you tried all five NIC's of the box? Maybe eth0 is not the one you think it should be.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 zmbiehntr over 16 years ago in reply to UrsWeiss

Tried 'em all, no dice. Reinstalled, worked fine - who knows!

New problems now, released lease off of my linksys router sucessfully and astaro picked it up. Ran a cable from eth1 into WAN on my linksys for wireless, and eth2 to my wired switch. No IP addresses.

I'm sure I screwed up DHCP somehow on here, I'm going to play around with it more and see what I can figure out. I've definitely jumped into more networking stuff than I have ever had to manually configure before

I'm looking forward to breaking stuff and learning more! [:D]

Any suggestions or links to FAQ's/Walkthroughs for first time set up are welcome.
Cancel
Vote Up 0 Vote Down

Cancel