This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Seems to overload system since 7.5 upgrade

Hello,

At present i can not tell you hardware specs of PC running my ASG 7.5. All i can say atm is it did not happen on 7.4 version.

If i leave a PC of mine on overnight or at least for awile i can come & sit down at it & find nothing will load & eventually times out. I try logging into Astaro FW from it but does the same. The only solution i have found is to simply power off than on Astaro PC. Once i have done this network is again seen as active.

Astaro use to run for week's/months as a set & forget system but now it seems there is a  need to restart every 24 hrs or less after it has been "overloaded" or not used for awhile.

Are hardware specs higher than before for 7.5?  Prevous build ran fine on same machine...

Regards


Andrew


This thread was automatically locked due to age.
Parents
  • The FAQ reads:
    Which hardware platforms can be used with the Astaro Security Gateway software solution?
    Users are able to use any Intel-compatible server or PC that meets the following minimum recommendations: Intel Pentium III 900 MHz, 512MB RAM, 10 GB hard disk drive and above.

    However from the beta forum:

    The hardware requirements for 7.500 are currently the same as 7.400

    Summary:
    The minimum hardware requirements for Astaro Security Gateway Software installations are:

    Version 7.400+
    CPU: 1.5Ghz Intel Pentium 4+ CPU (or equivalent x86_
    RAM: 1024 MB Ram
    Harddisk: 20 GB HDD
    CDROM: IDE or SCSI (see HCL for supported SCSI controller)
    NIC: at least 2 PCI NICs (see HCL for support chipsets)
  • Try to enable SSH and run "top" on it. There you may see what service makes a hight load.

    I already had the problem that IPS goes crazy and resulted in 100% CPU and network access problems.
Reply Children
No Data