This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Astaro/Hyper-V

Hi,

i know hyper-v is not supported by astaro. but i've seen some users in this forum running astaro on hyper-v.

can somebody please explain me how he/she installed astaro with this hypervisor?

I was unable to do this a few times and it would be a huge benefit for me because i've only this hypervisor with a lot of vms running...

thanks in advance

cheers
wolfman

This thread was automatically locked due to age.

Parents

0 Kingbuzzo over 16 years ago

you could mount their image in a desktop version of VMware and then import it into HV but it would probably easier just to mount the ISO and install it like you would normally...

setup two NICS, one LAN, one WAN and you should be good to go...

just be aware of any vulnerabilities in a Hypervisor could theoretically affect your setup and vice-versa...
Cancel
Vote Up 0 Vote Down

Cancel
0 Wolfman over 16 years ago in reply to Kingbuzzo

hmm... i tried to install astaro and set up 2 nics within hyper-v-manager but astaro was unable to find and use these...

are you sure with the solution? because my installation failed... :-(

Support drivers for Hyper-v

thanks
wolfman
Cancel
Vote Up 0 Vote Down

Cancel
0 tbrandl over 16 years ago in reply to Wolfman

We run an ACC on Hyper-V, which feels fine....
I am not sure, but IMHO ACC and AxG use the same Kernel.

Try to setup "Legacy Network" cards for your virtual machine and delete the Hyper-V-interfaces in the config. This could work.

Regards,
Thomas
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 tbrandl over 16 years ago in reply to Wolfman

We run an ACC on Hyper-V, which feels fine....
I am not sure, but IMHO ACC and AxG use the same Kernel.

Try to setup "Legacy Network" cards for your virtual machine and delete the Hyper-V-interfaces in the config. This could work.

Regards,
Thomas
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data