Hi,
I'm new in Astaro's Wolrd (and linux's world too) so, please excuse me for my (may be) obvious questions.
I'm trying to install ASG 7.4 on an old server "HP NetServer LC2000 U3" (with a PCI SCSI Controller) but installation fails:
---> INSTALLATION STEP 3 of 7 (Detecting Hardware)
(Alt+F4)
...
megaraid: aborting-115 cmd=28
...
(4)megaraid mbox: Wait for 2 commands to complete:300
(4)megaraid mbox: Wait for 2 commands to complete:295
(4)megaraid mbox: Wait for 2 commands to complete:290
... until 0 ....
...
(4)megaraid: aborting-117 cmd=28
(5)megaraid: hw error, not aborting
(5)megaraid: hw error, cannot reset
(5)megaraid: hw error, cannot reset
(5)megaraid: hw error, cannot reset
(6)sd 0:1:1:0: scsi: Device offlined - not ready after error recovery
(6)sd 0:1:1:0: SCSI error: return code 0x6000000
(4)end_request: I/O error, dev sdb, sector 0
...
(3)Buffer I/O error on device sdb, logical block 0
(3)sd 0:1:1:0: rejectiong I/O to offline device
(3)Buffer I/O error on device sdb, logical block 0
...
(Alt+F1)
---> INSTALLATION STEP 3 of 7 (Detected Hardware)
- Pentium III (Coppermine), 1000 MHz
- Pentium III (Coppermine), 1000 MHz
Disk(s):
- Size: 0 MB, MegaRAID LD0 RAID0 70006R
- Size: 0 MB, MegaRAID LD1 RAID5 34730R (unused)
CD-ROM
.....
(ENTER)
---> INSTALLATION STEP 4 of 7 -> OK
---> INSTALLATION STEP 5 of 7 -> OK
---> INSTALLATION STEP 6 of 7 -> (ENTER) -> (F8)
---> INSTALLATION STEP 7 of 7
Verifiyng package checksums ..........................:
(Alt+F3)
... installing ...
./rpm/.....: OK
./rpm/.....: OK
./rpm/.....: OK
... installing ...
Return code: 0
Error: Error opening /dev/sda: No such device or address
Formatting /dev/sda2 as SWAP
/dev/sda2: No such device or address
swapon: /dev/sda2: No such device or address
mkswap chain returned 1
PHASE END: install (ret=0)
unmount: dest//sys: No such file or directory
unmount: dest//proc: No such file or directory
unmount: dest//boot: No such file or directory
unmount: dest//opt/inst: No such file or directory
unmount: dest//var/storage: No such file or directory
unmount: dest//var/log: No such file or directory
unmount: dest//tmp: No such file or directory
unmount: dest//: Invalid argument
(Alt+F1)
---> INSTALLATION STEP 7 of 7 (Installation failed)
Please remove CD-ROM and restart the system
Astaro says BYE BYE... :-[
It seems that PCI SCSI controller Drtiver is required, rt?
But I don't know where I can found it and how to say to Astaro to use it during installation... :-(
Please, can anyone help me?
Regards,
ETHAN
This thread was automatically locked due to age.
