Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 10 replies
  • Subscribers 2 subscribers
  • Views 2423 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

additional network card

cokezero
Hello

I've four network cards on my astaro 6.314, i need more interfaces for a new internet line.
when i put in a new card every eth position change and nothing works any more.

what is the correct way to add a new network card?

thanks


This thread was automatically locked due to age.
Parents
  • 0
    I would think that you could reboot your core router to solve the problem globally.
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0
    I would think that you could reboot your core router to solve the problem globally.
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
  • 0 in reply to BAlfson
    hello

    thanks for your help

    I've done it over the sunday, nobody was in the office and i clear the cache on the other online servers.

    everything is ok and works fine. (wow version 7 is great! :-))

    thanks & cu
  • 0 in reply to cokezero
    Hello

    I have a new Problem after everything was good last week.

    I tried to make a masquerading roule but it wasn't good.
    (a special WS only over eth5, the new line)
    after i deleted the roule, i can't get a signal on eth5.

    the IP is correct, subnet also, gateway too, but Link is down.
    when i connect a notebook with the same configuration on the same cable it works.

    where is the problem???

    thanks
Cookie Information Banner