Hello guys,
hoping to get some help since astaro support has done me ZERO good after calling..
Currently i have a 5-Server network, running on a backbone of (3HP) and (1) Dell switch, my WAN (internet) comes in via DSL line over a standard 2-Wire DSL modem, then goes to my Current firewall a Symantec 360...
I'm slowly discovering that the Symantec must be acting as a router to some degree, and it does have a few static route's setup.
what I can't figure out, is that on my ASG 220, i have the LAN port up and visible on my network, and the WAN port configured as DHCP client to pick up an IP from my DSL modem, and also it sets up a Default gateway. everything is configured on my astaro security wise, but I am unable to get traffic through it when I put it inbetween my DSL modem and the LAN, I've even set the DNS server to use my LAN interface as the network's default gateway, but it still gets nothing through it.
do I need a router running in front, or behind the 220? or can i use the static route's to let traffic from the LAN, go through the filters, and then outbound on my WAN interface?
Help!
This thread was automatically locked due to age.
