Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Vonage installation

Can anyone explain in detail exactly how to configure Astero software gateway 7.404 to work with vonage?

I find some posts about setting them up but the te terms are a bit above me. I need to know what settings to change and where in the Astero menu to find them. I know quite a bit about software and hardware but very little about Astero and what all of the terms like "service groups" assiging RTP to a specific place and creating rules.

Thanks!


This thread was automatically locked due to age.
Parents
  • I have a packet 8 device for VoIP.  This is how I found out what was going on here with my packet 8 and what I did to make it work.

    I went to the network secrurity section and clicked on Packet Filter then I went and clicked on live log that way I could see the traffic trying to go through from my VoIP device.

    Ok so now I know that it's trying to go outside but the Astaro is denying it.
    So then what I did was added a new rule to the packet filter that looked like this.

    Source = VoiP Device (IP address of voip device mine is setup to be static)
    Service = Any
    Destination = Any
    Action = Allow 

    Once that was in place and enabled my VoIP went from a constant busy signal to a dial tone and now my house phones work great.  Feel free to PM me if you have any questions about this.  Thanks.

    I'm not entirely sure if allowing the service to be any but I figured this is for outbound traffic and it's a voip box so it can't really do much harm if any.  If someone knows more than me on that topic feel free to reply.  Thanks.
  • Astaro recommends using their VOIP Security features, but it doesn't hurt to have PF rule too.

    Barry
Reply Children
No Data
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?