Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 2 subscribers
  • Views 844 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Changing Default IP in AWG & AMG

BigBirdy
I am trying to eval both the AWG and AMG VM's running on a CentOS box and VMware Server 2. The problem is (still) the inability to create/set a default IP and so I am unable to reach 192.168.0.1 from either a computer given an ip of 192.168.0.10 and gateway of 192.168.0.1. My subnet, and IP of the VMWare server, is 192.168.1.x. Can I not change the IP of either AWG or AMG from the console. It would be a MAJOR benefit I am sure to many people if these products could be given the option to set an IP on install, or during initial configuration but NOT from the web GUI.


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to trollvottel
    OK, just for fun, I'll translate Mario's post...
    With the following description, you lose any and all support (Root Console is not supported by Astaro, only WebAdmin), but it works:

    Root Console:
    input: "cc"

    Then, the following:
    RAW
    lock_override
    OBJS
    itfparams
    primary
    REF_ItfParamsDefaultInternal[Internal,itfparams,primary]
    address=w.x.y.z
    netmask=w.x.y.z
    w
    exit

    After you enter the "w" your changes will be activated immediately. 
    __________________
    "Information Super Highway: Equipment allowing the fast transfer of large amounts of data (e.g. over the telephone network)" (German Dictionary, 21st Edition) 

    Mario Schmidt
    QA Engineer
    Astaro Corporation

    (Mario is poking fun at an "ancient" definition found in the Duden dictionary which is the "Oxford English Dictionary" for the German langauge.)

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • 0 in reply to BAlfson
    I got as far as 

    Switched to RAW mode
    127.0.0.1 OBJS itfparams primary >

    I then typed in

    REF_ItfParamsDefaultInternal[Internal,itfparams,primary]

    and was returned to the prompt.

    I then tried

    127.0.0.1 OBJS itfparams primary > address=192.168.1.162
    Unknown Command


    So where have I gone wrong?
Cookie Information Banner