This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Firmware 7.403 problem

After updating to firmware 7.403 the users get a user authentication prompt for any website they visit. Worked fine before the update. I had to disable user authentication so the users can get to the interweb.

And I did try flushing the authentication cache.

This thread was automatically locked due to age.

Parents

0 dabrudda over 16 years ago

I re-enabled user authentication and it seems to be working again. I guess the AWG was still updating after it rebooted.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 dabrudda over 16 years ago

I re-enabled user authentication and it seems to be working again. I guess the AWG was still updating after it rebooted.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 phil lock over 16 years ago in reply to dabrudda

dabrudda you will probably find that it takes about 10 minutes after a reboot for the system to resync and allow users through without the need to authenticate. ( well it takes 10 minutes here anyway [:)] )
Cancel
Vote Up 0 Vote Down

Cancel
0 Goldy_01 over 16 years ago in reply to phil lock

After updating to firmware 7.403, it was impossible to get any access to the web, CPU jumped to 90%, UpLink balancing-Multipath stop working and astaro couldn't establish connection to the 4 extra line in the Uplink balancing.
I was forced to reinstall 7.402.
Now everything work OK again.
[:(]
Cancel
Vote Up 0 Vote Down

Cancel